Ariens 992230 Uživatelský manuál stáhnout pdf (Strana 4)

08400165A 8/12 Page 2 of 4

Note: Support the mower deck on blocks or jack stands

before disconnecting links from mower lift arms to

prevent the deck from falling.

2. Remove hardware retaining foot plate and remove.

3. Raise the deck to the transport position and

disconnect the lift assist springs (6) from the mower

lift arms (1) on each side of the deck.

4. Slowly lower the deck to its lowest position.

5. Remove hardware retaining all four mower lift links

(2) from mower lift arms.

6. Remove the rear mower mounting pins (4)

connecting the mower mounting arms (3) to the

deck.

7. Slide mower deck out from under unit.

8. Remove front right and left lift arms.

9. From below front foot plate loosely install cradle

plate (item 1) using two 1/2 bolts (item 2) and two

flange nuts (item 4).

10. Using cradle plate as a template, mark off an area

at least 3/4" from the edge of the cradle plate in all

areas to be welded (see Weld Guide on page 4).

11. Remove the cradle plate and hardware.

12. Fully remove the paint in the marked areas (see

figure 3 on page 2). Take care not to remove any

steel. Clean area thoroughly prior to welding.

13. Mount and install cradle plate (item 1) using two 1/2

bolts (item 2), two flat washers (item 3), and two

flange nuts (item 4). Ensure that cradle plate is

centered and properly aligned before tightening

hardware (see Weld Guide on page 4).

14. Using C-clamps and/or locking pliers ensure that all

four welding surfaces are mated properly.

15. Weld the cradle plate into position using the weld

guide (see Weld Guide on page 4). If the deck is

still mounted to the tractor protect it with a welding

blanket.

CAUTION: The paint on the frame can catch fire and

continue to burn if it becomes too hot. Be prepared to

extinguish flame immediately if it begins to burn. To keep

welding zones cooler, alternate between different areas

or allow frame to cool between weld beads.

16. Upon completion of welding allow frame to cool

completely.

17. Dress welds as necessary and clean all areas

completely with isopropyl alcohol.

18. Coat all welds an unprotected steel with galvanizing

primer (item 7). Follow application instructions on

primer can.

19. Coat all welds and unprotected steel with enamel

paint provided with kit.

1. Mower Lift Arm

2. Mower Lift Link

3. Mower Mounting Arm

4. Mower Mounting Pin

5. Mounting Hardware

6. Lift Assist Spring

Figure 2

Figure 3

Remove paint from

all areas to be

welded.

1 2 3 4 5 6

Komentáře k této Příručce

Žádné komentáře

Ariens 992230 Uživatelský manuál Strana 4

Komentáře k této Příručce

Související produkty a manuály pro ne Ariens 992230