Ariens 920402 - Sno-Tek 24E Návod k obsluze stáhnout pdf (Strana 26)

EN – 25

Install Bushing

1. Install new bushing onto axle and align holes with

holes in frame.

2. Secure bushing to frame with two tapping screws from

inside frame and tighten hardware.

See Figure 39.

3. If reinstalling bushing on right side of frame, align spur

gear with pinion gear, center axle and reinstall roll pin

into axle.

4. Reinstall flat steel washer onto axle.

5. Reinstall bottom cover and secure with six hex bolts.

6. Reinstall wheels and secure with axle lock pins.

7. Return unit to operating position.

8. Fill fuel tank and reconnect spark plug wire.

CHUTE GEAR REPLACEMENT

Remove Pinion Gear

NOTICE: Save all hardware for reinstallation unless

specified otherwise.

1. Stop engine, remove key and wait for all moving parts

to stop and for hot parts to cool.

2. Disconnect spark plug wire from engine.

See Figure 40.

3. Remove hardware retaining chute gear cover to pinion

gear bracket and remove cover.

4. Remove spring clip from chute rotation rod and

remove rod.

Figure 39

1. Axle

2. Spur Gear

3. Pinion Gear

Figure 40

1. Tapping Screw

2. Chute Gear Cover

3. Spring Clip

4. Chute Rotation Rod

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Žádné komentáře

Ariens 920402 - Sno-Tek 24E Návod k obsluze Strana 26