Ariens 929000 Uživatelský manuál stáhnout pdf (Strana 50)

ASSEMBLY

INSTALL ROLL PIN

FIGURE 1

STEERING WHEEL

Install the steering wheel on the column and

secure with a roll pin as shown in Figure 1.

SERVICE BAHERY

Remove the battery from the tractor. This will

prevent any accidentally spilled electrolyte from

damaging the tractor.

Electrolyte is not furnished with the tractor. Use

only battery grade sulphuric acid electrolyte with 1.265

specific gravity plus or minus 0.005 corrected to 80®F.

Prepare battery as follows:

1. Remove vent plugs.

2. With battery removed from the tractor, fill each

cell with electrolyte until electrolyte level rises to split

ring at the bottom of the filler tube. DO NOT OVERFILL.

BE CAREFUL! ELECTROLYTE CONTAINS SUL

PHURIC ACID WHICH IS HARMFUL TO SKIN,

EYES AND CLOTHING. HANDLE WITH EX

TREME CARE. IF SPILLAGE OCCURS ON

BODY OR CLOTHING, RINSE AT ONCE WITH

WATER.

POSITIVE (+)

TERMINAL

NEGATIVE {-) TERMINAL

FIGURE 2

3. After filling cells, wait five to ten minutes and

add additional electrolyte if necessary to bring electro

lyte to proper level.

4. Charge battery with a 12-volt charger for 30

minutes at 4 to 6 amps.

5. After charging, add electrolyte until the level is

up to the split ring in the filler tube. Thereafter, add

only clean, distilled water as use and time requires.

6. Replace vent caps. Clean and dry battery ex

terior.

INSTALL BATTERY

Place the battery in the battery carrier as shown in

Figure 2 with the positive (-F) terminal to the right

side of the tractor.

Secure the battery in place with the battery hold

down as shown in Figure 3. Do not overtighten the

hold-down nuts.

Attach the battery cable to the positive (4-) termin

al and the ground cable to the negative (-) terminal as

shown in Figure 43. Tighten the cables to the terminals

securely.

Coat the terminals and the battery cable ends with

a light coat of grease or petroleum jelly to prevent

corrosion.

ENGINE OIL

Fill the engine crankcase (Figure 4).|. Use Ariens

Gard-N-Yard MS lOW-30 oil when using lawn and

garden attachments, use Ariens Sno-Thro oil (SAE

5W-20 MS classification) when using snow removal at

tachments.

Do not overfill — the oil level must never exceed

the full mark.

TRANSMISSION OIL LEVEL (Gear Shift Model 929001)

Check the oil level using the following procedure:

1. Place tractor on a level surface.

2. Raise rear deck to gain access to the transmis

sion check level plug.

3. Remove check plug. Figure 4. Oil should seep

out of the check plug hole. If the level is too low,

remove the filler plug and add Ariens MP-90 Premium

Gear Lube (SAE 90-EP) weight transmission oil until the

level is correct.

PAGE 50

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 83 84

Komentáře k této Příručce

Žádné komentáře

Ariens 929000 Uživatelský manuál Strana 50

Komentáře k této Příručce

Související produkty a manuály pro Zahradnické vybavení Ariens 929000